Michenka


Electronic devices for trucks :


1. Electronic regulators of line MT 05 – manufactured designs: MT 05.7 and MT 05.8

- These are microprocessor control units controlling the cooling system of TATRA vehicles
- these are el. exchangeable with formerly manufactured JW5 (MT 05 have only smaller case dimensions)

- replacements: JW5.007 = MT 05.7, JW5.008 = MT 05.8

 

- TATRA a.s. item for MT 05.7..........443 811 022 000
- TATRA a.s. item for MT 05.8..........                -

 

 

2. Electronic regulators of line MT 25 – i.e. MT 25.3 and MT25.4  – production terminated 


 – replacement is MT30.01
These control units control, besides the cooling system, also electronic preheating of engines and control exhaust brake in TATRA vehicles. The units are equipped with control and recording system for recording of exceeded permissible values of some operational parameters of the engine units into its permanent memory EEPROM.
They are el. exchangeable with formerly manufactured JW25 (MT 25 have only smaller case dimension)

replacements: JW25.003 = MT 25.3, JW25.004 = MT 25.4

 

- TATRA a.s. item for MT 25.3..........443 811 020 000
- TATRA a.s. item for MT 25.4..........443 811 021 000

 

 

3. Electronic power regulator ERV-1

This is an analogue regulator, which controls the system of power limits of TATRA engines

 

- TATRA a.s. item for ERV-1..........443 811 019 000


 

4. Electronic unit EMB-02 – production terminated

The unit controls exhaust brake system of TATRA vehicles


 

5. Voltage exchanger MCU 12/24

The voltage exchanger increases 12 V to 24 V in vehicles equipped with 12V main


 

6. Control button lighting corrector KPO-24 – production terminated

The unit controls the shine of bulbs in control buttons using potentiometer in pulsing regime


 

7. Control button lighting corrector KPO-26

continuously controls bulb shine as KPO-24, the control element is three position switch, setup light level is saved in EEPROM memory when the power is off, then, when the device is put into operation again, the last value of bulb lighting level is setup in device control buttons.

 

- TATRA a.s. item for KPO-26..........443 811 024 000


 

8. Signal adapter SAD-1

the adapter is intended for adjustment of signal on trajectory for navigation computers of TATRA-DAKAR vehicles


 

9. Electronic regulators of line MT 30 – manufactured in MT 30.01 and MT 30.02 designs

This microprocessor controlled units control, besides the cooling system, also electrical preheating of engine and exhaust brake in TATRA vehicles. The units are programmed at the user’s facility with certain regulation and identification parameters. All units are equipped with control and recording system for recording of exceeded permissible values of some operational parameters of the engine units into its permanent memory EEPROM. Further, they are equipped with communication pins for communication with superior computer system.

The MT 30.02 units in addition enable engine disconnection using car key in switch case. It is necessary to arrange permanent power +24V (connector “30”) for their pin 3, in the vehicle’s main.
After programming by authorized persons (TATRA a.s. dealers after passing appropriate training) these units replace units of line MT25.

 

- TATRA a.s. item for MT 30.01..........443 811 023 000
- TATRA a.s. item for MT 30.02..........443 811 025 000


 

10. Alternator filter FA28V100A

The filter is intended for alternator interference for certain special applications of TATRA vehicles.
This filter replaces formerly manufactured filter FA28V65A.

 

- TATRA a.s. item for FA28V100A......443 412 020 000

 

 

11. Alternator filter FA28V125A

The filter is intended for alternator interference for certain special applications of TATRA vehicles.
 

- TATRA a.s. item for FA28V125A......443 811 028 000

 


© 2007, Vyrobilo grafické studio DesignPro.cz | XHTML & CSS Valid | ČESKÁ VERZE